Nissan Forum banner
1 - 1 of 1 Posts

9 Posts
Discussion Starter · #1 ·
Hi All

I have been lookin around for info on a ca20 throtle position switch,
it has 2 sets of wires both sets of 3, 1 at the front of the unit that has top and centre pin connected at idle and opens just above idle and the next is the centre and bottom pin that connects at apx full throttle, That I understand but the second set of wires that come out of the top of the unit and go to a 3 pin plug I am unsure what they do?????

I have heard of position switches and position sensors and my manual only shows and describes the front wiring setup

So whats the deal?????????? can anyone help
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.