[boost_boy]

If you're interested in this swap, then pay close attention to what's needed. From a 1988 nissan pulsar SE you'll need: Tranny, flywheel, all mounts and bolts, shifter & linkage, gas pedal, throttle cable, wiring harness to include engine and car portion, radiator, pulsar fuel pump, instrument cluster has to be modified and it takes some skill at doing it because you'll also need the 1987-89 sentra GXE or SE cluster as well. It sounds like alot, but once you've installed this motor you won't be sorry. Be sure to check the compression of this pulsar engine and make sure it's from an 88 pulsar and not 89. The 1989 CA18DE's were decompressed and that sucks. Have fun.....................

boost_boy

x2 1990 b12's w/CA18DET's/ [email protected] for the less modded B12 and to be announced for the built B12 and a chillin 1993 Ford Taurus SHO (auto).

 

[boost_boy]

Mounts! Start out with a fresh set of mounts. There is no welding required for this swap so don't worry. If you're going to do it yourself, you'll have fun and get some headaches, but I won't let you fail. The finished product will be O-S--Sweet.....

 

[boost_boy]

No man, you're not asking too many questions; as a matter of fact fire away. I have many CA18DET parts and the jap spec parts seem to hold up longer. I've never had a coil pack take a crap on me with every DET I've purchased. I've busted pistons, but that's about it. Can't hurt the block, crank and rods even at 25 psi. It all comes down to fuel. Hey man, 1989sentra is already interested in one engine I have so if you're interested you can take dibbs on the other. One has a stock turbo, one has an upgraded turbo that I used to boost to 22psi. I'm not trying to seel you anything, just trying narrow your options and searches. For you the swap wouldn't be so bad because your car is set up. I also have 2 JWT 1988 nissan pulsar ECU's eprommed and set up for the maxima's AFM. They each cost me $599 minus the AFM, so if you're interested, I'll let them go for a reasonable price. I have 6 CAS's and 8 coil packs on rails. Do the swap, you won't regret it and people can watch your license plate until you disappear.

 

[boost_boy]

You can actually do the swap in your garage or anywhere you want. I did both of my cars at my sisters house with a standard mm socket set (10-19mm) with the addition of a 32mm for the cv axle nuts. If you need anything, don't hesitate to rattle my cage.