Nissan Forum banner

1 - 18 of 18 Posts

·
Registered
Joined
·
96 Posts
Discussion Starter #1
Anyone have any success in doing this? What exactly has to be done? I would prefer to use stock Nissan hardbody seats and a center console from an extra cab.

thanks

peter
 

·
Registered
Joined
·
85 Posts
i am pretty new to nissans what does this int look like??:newbie:
 

·
Registered
Joined
·
41 Posts
my donor truck has nice looking maroon buckets (89 hb) but does anyone know how they sit. will the seat back be too far forward in a single cab?
 

·
Registered
Joined
·
153 Posts
Maybe you can check out different years too. I have 97 recliner seats in mine. I had to use my 720 brackets-the 97 brackets were taller in the front. The front seat bolts fit the brakets perfectly,but I had to drill the brackets for the rear seat bolts. That was all I had to do, so some other year D21 seats may fit yours fine.
Check out some of the U-Pick/Pull-It or similar lots if any are around you. I found mine for $17 each.
 

·
Registered
Joined
·
96 Posts
Discussion Starter #11
I should have been clearer on this.. The truck I have now is a bench seat 1997. I would get the seats from a later 96-97 hardbody
 

·
Registered
Joined
·
2,220 Posts
any bucket seat from 86.5-97 HB or 86.5-95 pathfinder will bolt right in. no drilling is needed. my seats are all the way back and sit very comfortably. I would look for the seats that leg support is adjustable. If I get a chance I will post pics. I also put a center console from a ford taurus 95ish yr which has a nice and good height for an arm rest with the option of a jump seat.
 
1 - 18 of 18 Posts
Top