Nissan Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
I recently washed my car and sprayed down the engine. when i started my car and shifted into drive to move it (automatic) there was a loud THUD as my motor smacked the bottom of my hood, i have broken a motor mount, front i think, its ok-ish if i let it run for about ten minutes and roll a little b4 i shift but other wise it lurches and makes a loud noise. what is the method for checking/replacing the mounts front and rear and what is the chance of breaking one and cracking the other? i already have a parts yard Nissan Only Werckers of rancho cardova for parts, i just need a good estimate for both mounts and advice on best mothod of replacement. Thanks
 

· Registered
Joined
·
126 Posts
small piece... big job... you'll probably need a cherry picker to hold the engine up while you replace the mount(s).
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top