nice
what kind of improvement are u expecting? i using a t25bb on my car and it spools so fast...
what kind of improvement are u expecting? i using a t25bb on my car and it spools so fast...
Before and after pics. E. Honed T28 Exh. housing
3
Recently purchased a T28 from Louis, he sent the EX housing to extrude hone per my request. Here are a few pics. I thought a few people ahd asked about this so Ifigured I'd share them.
Before
![]()
After
![]()
![]()
You can see the bumps in the housing are significantly reduced. You can't even see the .86 on the inside of the extrude honed
housing. Looks good, not bad for $75 plus shipping.
Before
After
You can see the bumps in the housing are significantly reduced. You can't even see the .86 on the inside of the extrude honed
housing. Looks good, not bad for $75 plus shipping.
1 - 7 of 7 Posts
What times are you running? We should hit the strip against the honda kids at firebird on SCO nights together... You down?javierb14 said:nice
SCO nights resume Sept. 26th... I should have my car together again by then. Hopefully.. lower et's for me....
ya but not yet...i still have a couple of things to finish:
finish wideband 02 installation
finish exhaust, running open DP right now
install boost controller only @ 5psi right now
finish mounting gauges
replace clutch
after im done i can crank up the boost
finish wideband 02 installation
finish exhaust, running open DP right now
install boost controller only @ 5psi right now
finish mounting gauges
replace clutch
after im done i can crank up the boost
welll
as far as improvements it has yet to be tested. Project 1.6 is running a straight T28 and with the pulse converter manifold it is spooling up rather quickly. I'd say maybe a few hundred RPM's but that is just a guess based on previous people's experience with this. Time will ultimately tell!javierb14 said:nice
1 - 7 of 7 Posts
