Nissan Forum banner
1 - 9 of 9 Posts

· Registered
11 Posts
Discussion Starter · #1 ·
Hi i did a little research for ecu pinout but with no success , can someone help me with this ?

i notice that some water has been on my ecu so i unplugged it to put it in a plastic box or someting then, after i plugged it back, i notice a broken wire ! I plug it back where , i think , it would go according to the chilton book but then i notice another broken wire... the wire are pretty tight down there and with the cold i am looking for someting better for the wiring diagram of the chilton.

1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.