Nissan Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
87 Posts
I just changed mine in my 92 se-r, drivers side.....i went to the dealership, it was 7 bux, u should def get one from there or ur just wasting ur time. Use the proper puller. I wedged a flathead and gauged up the tranny and made notches in it. Then it leaked real bad with a new seal. So i put silicon around it and then installed it... Just saying use the proper seal removal tool and installer and u shouldnt have a problem, I am sure the passenger side is the same as the drivers..at least the removal and install g/l!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top