Nissan Forum banner

1 - 7 of 7 Posts

·
..::SR20 MuthaF*%@#$::..
Joined
·
457 Posts
Discussion Starter #1
i've changed it many times but i usually rent it from oriely's but im gonna borrw it from a friend that goes to tech school ,but was wondering wat the size for the axel bolt was. thanks
 

·
Registered
Joined
·
195 Posts
StevenLK said:
i've changed it many times but i usually rent it from oriely's but im gonna borrw it from a friend that goes to tech school ,but was wondering wat the size for the axel bolt was. thanks
axle nut = 32mm, torque to 145 - 203 ft.lbs.
 

·
Registered
Joined
·
16 Posts
StevenLK said:
thanks jp . . .
Note to wrench turner, you will want to make sure your 32 mil or 1 1/4 inch socket is a deep socket, otherwise you will have a difficult time keeping it on the nut while trying to break the stock 150 ft/lb axel bolt loose.
Make sure you have either a good breaker bar, or an impact wrench.
Good luck!
 

·
Destroyer of worlds.
Joined
·
874 Posts
nhladky said:
N
Make sure you have either a good breaker bar, or an impact wrench.
Good luck!
a 3-4 ft section of steel pipe works well, and is much cheaper than an impact wrench(should you not have one)
 
1 - 7 of 7 Posts
Top