Nissan Forum banner

1 - 6 of 6 Posts

·
Banned
Joined
·
395 Posts
Discussion Starter #1
ok guys, i got the halos a while back and am now trying to do the installation myself.........now i was going over the instructions on NPM and it calls for a 9003 female socket. i tried kragen, pepboys and even the dealership..............no one carries it.now where can i find one of these?!?! thanks for your help
 

·
Registered
Joined
·
249 Posts
Your car should have a 9004 socket
 

·
Registered
Joined
·
249 Posts
95-98 has 9004 as far as I know
 

·
Registered
Joined
·
75 Posts
It is a 9004. If you want to be able to remove them later and not have to splice your factory wiring, take apart your current 9004 bulbs. Just pull off the glass part out (you have to pull pretty hard and dont be afraid to brake it), you will then be left with three prongs. Get a circuit tester and figure out wich one if the high bean, low beam, and ground. then all you have to do is sodder the wiring harness to the bulb and WHALA, you have a custum wiring harness. It sounds a bit difficult but believe me its not, I did it to my car and it work perfectly. E-mail me if you have any other questions about the install.

Martin
 
1 - 6 of 6 Posts
Top