Nissan Forum banner

1 - 3 of 3 Posts
S

·
Guest
Joined
·
0 Posts
Discussion Starter #1
how do I adjust the clutch on my B13 SE-R? I have to floor the pedal to get the clutch to disengage.
thanks

Also, I have a hesitation problem at light throttle, I am guessing it is a problem with the computer turnign off the AAC at the right time. Can I adjust this?
thanks again
 

·
Registered
Joined
·
413 Posts
suchy01 said:
how do I adjust the clutch on my B13 SE-R? I have to floor the pedal to get the clutch to disengage.
thanks
Directly under the intake piping that runs from the MAF to the throttle body, you will see the clutch cable. At that point you will see a bracket clamp, thumbwheel and locknut attached to the threaded section of the clutch cable. Loosen the locknut (10mm I believe) and then start to tighten the other thumbwheel so you are actually given the cable some tension. Do just a little at a time then test the pedal. Continue until it feels comfortable to you. Tighten the locknut down and go for a drive!

Tighten the cable brings he engage/disengage higher up.
Loosening it brings it closer to the floor.

Good luck
 
1 - 3 of 3 Posts
Top