Nissan Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
86 Posts
Discussion Starter · #1 ·
Ok so, after just recently fixing an engine issue, i have decided to lower this truck. It's a 2 wheel drive reg. cab with the ka24e in it. I was wondering if anyone has any ideas on lowering this truck? I don't want to use airbags, too expensive. Hopefully someone can come up with an answer for me. I know on the toyota's you could just "flip" the torsion bars, but I don't think you can do it on this. Any help?
 

· Registered
Joined
·
86 Posts
Discussion Starter · #21 ·
Yeah I might have to do the same thing. The only problem is, it's going to have to wait. I just put on pathfinder chrome wheels and 205/60/r15 tires. my front end is making a lot of noise and everything wheel wise is not bent up and is balanced. I just discovered on my ball joints the rubber boots are broken, thus have leaked all the grease out, probably destroying them. So, i think is hould fix that before lowering the truck. WHen turnign you get banging and noise. I just had to put a rear in this thing as well, so I def. can tell this truck was not well maintained. 160,000 miles and dying.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top