Nissan Forum banner
1 - 1 of 1 Posts

6 Posts
Discussion Starter · #1 ·
I pulled up to a gas station and killed the engine, filled up, and then went to start it. Cranks fine, but won't start. I have replaced the Dist. cap and rotor button. the plugs went 3 months old same as wires. I checked to see if I was getting fuel, and I am. At least to the fuel regulator. Spark is getting through all the wires. The engine doesn't even "stumble" like it is trying to start. There are a few things I planned on checking, but I would see what you guys thought.

Here is what I am going to check and the order in which I intend to check them.

- Test the fuel injector relay
- Take off the fuel rail and see if I am getting fuel through all injectors.
- Replace ECM

Also is where is the crankshaft sensor located on this car because I think it may be it.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.