Nissan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I have an e16i whith a 3 speed auto tranny. Everything ran fine until the motor blew. I put a salvaged e16i motor in it which runs fine. After the swap the car ran for a few days but shifted a little hard now it only goes into gear once in a while and only for a second before it slips out. Any suggestions.......?

The tranny doesn't leak fluid and has the right amount in it...
Should I just put a new transmission on it?
 
1 - 1 of 1 Posts
Top