Nissan Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello all,

I recently had a discount shop swap my 280ZX motor into my 280Z. It runs, but they couldn’t get the throttle linkage right. The pedal sits almost on the floor and there are pieces of wood on the outside firewall keeping the linkage in place. Has anybody done this swap before or have any ideas for a solution? It was suggested to me to swap the S30 intake manifold on so I’m going to see if I have the complete manifold (the previous owner did a bit of scavenging). Any other thought would be appreciated!

Thanks
 
1 - 1 of 1 Posts
Top