Nissan Forum banner
1 - 2 of 2 Posts

1 Posts
Discussion Starter · #1 ·
My car stalls after being warmed up and will not start. As the car cools down it tries to fire up but fails. When the car is cool it will start. I hooked it up to a diagnostic unit and it gave me the following codes:

Camshaft Position
Sensor A Circuit
(Bank 1 or single sensor)

Knock Sensor 1
Circuit (Bank 1)

Vehicle Speed Sensor

I erased the codes, started the engine and only the P0325 knock sensor was shown.

Would a failed knock show similar symptoms that I'm having? Do my symptoms indicate a failure of one of the other two sensors? Thanks in advance for all of your help.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.