Nissan Forum banner

1 - 5 of 5 Posts
F

·
Guest
Joined
·
0 Posts
Discussion Starter #1
i have a 97 200sx se-r. the wire harness is fried, i have a wire harness out of 95 1.6 sentra. will they interchange or do i have to get the 2.0 harness? thanx for the info.
 
M

·
Guest
Joined
·
0 Posts
Discussion Starter #2
Wire Harness

I'm not sure but I think you would have to get the one off the se-r
but you should be able to tell by looking at them...
 

·
Registered
Joined
·
68 Posts
it should work from wut ive been told, only problem is the 1.l6 harness is usually shorter, but if u can lengthen the wires it should work. keep in mind i havent SEEN this but have heard it and i read it sumwhere too.... nissan performancemag maybe... anyways GOOD LUCK
 

·
Registered
Joined
·
11 Posts
iirc you need the sr wiring harness. do a search on here or try b15sentra.net or sr20deforum.com

i know its been discussed before
 

·
bitter old man
Joined
·
1,456 Posts
The two harnesses are different, primarily due to sensors in different locations.

Cheap but difficult is to alter GA16 wire lengths, expensive but easy is new SR20 harness.
 
1 - 5 of 5 Posts
Top