Nissan Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. QG18 1.8L Engine
    Hi, I've almost finished putting a 2000-2002 QG18DE engine from an Almera into a K11 Micra, which will be running on a Megasquirt ECU. I'm getting to the point where I'm going to need to create a base tune but can't find any information as to what sort of timing these engines run, apart from...
  2. Less known Nissan models
    Hi, I replaced my ignition barrel and got a new key. After I plugged in the new ignition with new key and start, the car would only crank but will not start. Took the new ignition barrel and the old key to a locksmith and was told that there was no transponder in the old key. I even tried...
  3. General Frontier/Navara Discussion
    I'm replacing the distributor on my 99 nissan frontier and I can't get the ignition timing to 15 BTDC. With the old one I was able to set it to 15 BTDC but on my new one I can't retard it any further than 18 BTDC by turning the distributor. Any idea why this would be? Bad distributor...
  4. General Frontier/Navara Discussion
    I have a bad camshaft sensor in my old distributor on my 99 nissan frontier so I replaced it with a new one. With the old distributor I was able to get it to the right specks at 15 BTDC but with the new one I can't get it any more advanced than 18-20 degrees. This is causing poor gas millage...
  5. General Frontier/Navara Discussion
    I have a bad camshaft sensor in my old distributor on my 99 nissan frontier so I replaced it with a new one. With the old distributor I was able to get it to the right specks at 15 BTDC but with the new one I can't get it any more advanced than 18-20 degrees. This is causing poor gas millage...
1-5 of 5 Results
Top