Search Results for ‘distributor’

So as I have been working on my 2.4L 2000 nissan frontier and I knew I was having timing problems. I'm pretty sure I need to pull the timing plate and replace timing chain and components. I wanted to check here first. Before I jump into it. I cleaned my crank shaft pully and found the timing...

my old distributor was busted so i bought an aftermarket distributor... when i installed it, it does not work... it just cranks up but won't start.... then i tried to use my friend's distributor and it worked fine.... i already went to the shop where i bought my distributor and had it replaced...

I'm replacing the distributor on my 99 nissan frontier and I can't get the ignition timing to 15 BTDC. With the old one I was able to set it to 15 BTDC but on my new one I can't retard it any further than 18 BTDC by turning the distributor. Any idea why this would be? Bad distributor...

I have a bad camshaft sensor in my old distributor on my 99 nissan frontier so I replaced it with a new one. With the old distributor I was able to get it to the right specks at 15 BTDC but with the new one I can't get it any more advanced than 18-20 degrees. This is causing poor gas millage...

I have a bad camshaft sensor in my old distributor on my 99 nissan frontier so I replaced it with a new one. With the old distributor I was able to get it to the right specks at 15 BTDC but with the new one I can't get it any more advanced than 18-20 degrees. This is causing poor gas millage...

Hi I am new here so sorry if this post is in a different section, I put it under pathfinder because I could not find xterra section. I have an Xterra 2001 3.3l v6 and couple weeks back I have encountered a problem. When I was driving all was good, when I stopped at a light or a stop, the engine...