Nissan Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. X-Trail
    I have a 2002 Nissan Xtrail T30. So a little while ago I was at work and went to get into my car and it would crank but not start. I had to turn the ignition on but not start 5 times before it would start. the ECU light was still coming on and I put scanner on it and it said to change the...
  2. CA/E-Series Engines
    Hey everyone, I´ve been searching all over the web with 0 results so i thought someone on here must know.. What I´m looking for is the spec. for the E13 camshaft. I don´t want to rip my fairly freshly rebuilt head apart just to measure it in the lathe so before i go to that last resort i...
  3. 1st Generation 240SX (1989-1994)
    Hi, I am just about to purchase cams but have a few concerns about my setup because its a bit odd. I am running a S13 block with S15 head, and within the head VTC is going to be deleted and replaced with S13 cam gears. Because I don't need oil pressure to operate VTC anymore, should I go with...
  4. 1st/2nd Generation Sentra/Pulsar (1982–1990)
    I know that the Eurocam is the go to for an aftermarket performance cam for the B12 Sentra. However, since they are impossible to find these days, is there an alternative? I was thinking maybe the cam from a later model Sentra might suffice, but I’m not sure.
  5. Pathfinder
    2006 PF Se(4×4) 200,000 mi. Engine started to cut of during turns/ slowing down. Sometimes would cut off on the Interstate. Replaced camshaft and crankshaft sensors. The very next week it ran hot, heard meat clunking under the PF. Drove while hot to a safe place and parked. Mechanic that...
1-5 of 5 Results
Top