spazster

I need a new driveshaft and I have found a 20 lb 1 peice steel driveshaft and the stock is a 35lb 2 peice I was wondering if anyone has done this upgrade and how it has worked out. please reply if u have any info i would greatly appreciate it. Also i was wondering if it would vibrate anything in a bad way of or up agianst any thing or if the fact that the center u joint not being there would bend anything or not fit right im mainly doing this for replacement my last one is bad thanks again.

asleepz

Well it will decrease your spining mass so you might get a couple HP out of it

FDTT

Well you woudl gain a few Hp because there is less rotating mass like stated above. But you may experance a bit more vibration as well. The U joint that was joining the OE driveshaft absorbs alot of shock from the driveline. I dont think it will be a big deal. Put that one in and let us knwo how it goes.