morepower2

Who hoo!

I got 559 hp and 549 lb/ft of torque at 24 psi of boost burning a mxture of VP C16 with a little pump gas. I probably could have gotten more but I did not have enough preload on the internal wastegate cans and they were blowing open due to backpressure so I could not get more boost than that.

I figure with some tweeking I might be able to run as much as 26 psi on these particular turbos if I jack the wastegate preload way up.

On 91 octane pump gas I made 495 hp and 490 lb/ft of torque at 20 psi with water injection.

The motor is really smooth on the dyno, most high powered cars I have dynoed sound like they are about to blow, but mine is smooth and quiet. Maybe its the Fisher balancer.

Mike

peter96

Damn! That's great news Mike.
What a monster
Congrats!
Peter J

boostinzx

You have one sweet car man... im new to the forum and i must say that you have one bad car.... i wish that my Z was half of what your is;]

91flz

hey mike awsome car. ive been watching the build up for years. i know you didnt build it for the 1/4 mile but im shure we could do a little better than that 12 sec pass. i ran a 11.754sec @ 116.288 on stock turbos. my 60 ft was 1.697. my car is is a white 91 ztt with 101 miles and engin and turbos were never replaced . you can check out my time slip on www.z32racing .com .look under top 5 stock tts. mine is #1 . you should expect much more from that monster you built. it truely is beutifull if you need a driver im always willing

ken
www.rztperformance.com

91 300zx tt white :

jwt single pop intake
jwt ecu
greddy profec b boost controller
greddy sp exhaust
rzt 3"down pipes
rzt 2"1/2 test pipes
rc 555 1njectors
Mickey Thompson ET street tires 26x11.5-16
rps clutch
#6 spark plugsand
and NO nos!!!