Swap a manual transmission in a 90 Automatic 300ZX TT.
Is it possible?
Yes, this is a possible swap, in fact some people have done SO its VERY POSSIBLE
If so, what are the necessary parts to complete the swap? and how much would it cost???
-Manual transmission assembly
This can be had out of a wrecking yard that specilizes in Z's such as Z1motorsports web address http://z1motorsports.com/
-manual pedal cluster
Again this can be gotten from the wrecking yard
-Probably Manual ECU
If memory serves me right, you should be able to use your AUTOMATIC ECU with a manual transmission, but you can't do the opposite (e.g. Manual transmission for an Automatic)
-Clutch master cylinder?
The turbo units used a clutch booster not sure how much that costs but for a non turbo the clutch master cylinder was ~100 at nissan, the slave cylinder (the thing that pushes the clutch fork in is ~43 new at nissan
you will also most likely need to have all the "plumbing" for the hydrallic fluid, could just get some brake line at checker, autozone, napa, etc... and bend it accordingly for $25 dollars for it all, or you could do it with bradied stainless steel lines which would be extremely expensive.
You may consider looking at this website
WWW.TWINTURBO.NET its a great place to learn (they are kinda of ignorant as far as newbies go, but don't let it scare you off, the boards gotten a little bad recently)
As far as your honda what did you have, did you have the b16a, b18, b20, My friend just did a swap on his 92 integra he dropped the 1.8 and put in the b16a (its getting better and better)
joe a.k.a wIgGY a.k.a WIGgLEs
Linear Mode
