A/C compressor clutch tool needed

Apr 30th, 2002, 03:31 PM

Guess I'll start this forum off with a question:

Does anyone know what the thread is on the A/C compressor clutch? I need to pull the clutch plate and shim it to solve the slight dragging it has when not engaged, but I'd like to have the tool before I dig into it. I've got access to several Snap-On pullers but none is specifically listed for Nissan so I'd like to check the thread (the FSM does not have this info). Maybe I'll just buy the Nissan puller but I figure I'll only need it this once.

Any suggestions? Thanks,
Darin

May 1st, 2002, 11:54 AM

Hi Darrin!

The 1993 Service Manaul shows two special tools for A/C pulley work. The removal tool is shown as KV99233040 or J26720a. The installation tool is shown as KV99234160 or J37839.

Hope this helps!

Tom Bell

May 1st, 2002, 02:55 PM

Thanks for the info. I did see these parts in the manual but I was hoping to use a generic kit with several different sizes, available from Snap-On (borrowed from a mechanic friend.) I wanted to try to confirm the thread size, though, before I started so I'd know if the Snap-On kit would work or if I'd have to go ahead and order the Nissan tool. I figured it was a shot in the dark but you never know.

Now I just have to search back to find the source for Nissan tools. Anyone remember this off the top of their head?

Thanks again, Tom.
-Darin

May 2nd, 2002, 06:32 AM

Nissan gets its tools from Kent-Moore. They can be reached at (800) 345-2233. You should use the J- part number to order Nissan-specific parts.

You might contact a dealership locally first, and see if they would agree to loan you the tools. Some do - most don't.

Hope this helps!

May 2nd, 2002, 08:15 AM

Thanks Tom! That's the place. I will call and check on this. Here's a kit like the one my local mechanic buddy has:

http://www.acsource.com/cgi-bin/Soft...181+1020336973

Unfortunately, the closest Nissan dealership is 60+ miles away, and they're a little difficult to work with anyway. That's why I do almost all my service work myself (that, and $$), but luckily I have a local guy that's quite capable as well.

Thanks again, Tom.
-Darin