can someone measure for me please asap

95_altima_ka24de · Mar 30th, 2008, 04:17 PM

please someone......alright i need a measurement asap from the front of the front wheel well on the bottom of the fender from one side to the other (the drivers side to the pasenger side... strait across ..not all the way around the bumper) please help me out

95_altima_ka24de · Mar 30th, 2008, 04:18 PM

stock fenders please

**Asleep** · Mar 30th, 2008, 04:29 PM

give me a few minutes. putting on my shoes to grab my egr knock off plate. while im out there, ill get that measurement.

**Asleep** · Mar 30th, 2008, 04:42 PM

ok.
to the best of my ability - by myself, i measured this for you...
from edge of fender to edge of fender was approximately 62.5-63".
hope this works for you...
what are you checking for?

95_altima_ka24de · Mar 30th, 2008, 06:35 PM

thanks your a good man lol thank you very much measuring to see if a civic mugan lip will fit on our stock bumper ...well how close it is ..i have seen it done looks good ..but ned to see how much i will have to alter it ....gota go measure my cousins civ in a min i will let you know how it goes...

check out my alty

MySpace.com - nismo - 27 - Male - PUYALLUP, Washington - www.myspace.com/95_nissan_altima

95_altima_ka24de · Mar 31st, 2008, 01:58 AM

62 1/2" distence from inside of the fenderss or from outside to out outside of the bottom of the fenders? its close either way thank you very much

**Asleep** · Mar 31st, 2008, 02:42 PM

outside to outside of the fender.
91-94ish accord lips will work too iirc.

95_altima_ka24de · Apr 1st, 2008, 01:05 AM

Quote:

Originally Posted by Asleep

outside to outside of the fender.
91-94ish accord lips will work too iirc.

better or about the same?