xx_blkbird

Funny thing today with my '03frontier. The passenger side wiper
decided to not work,driver's side is just fine.Well I figure it's
probably the linkage that has disconnected but to get to it there is
that plastic cover that needs to be removed.How do you get this
thing out? and what could be the problem before I start tinkering
with this?
TIA

SPEEDO

sounds like a retainer ball broke (its plastic or synthetic metal,lol) if I remember right they only run a couple of bucks

xx_blkbird

Where is this retainer ball located? and do I have to remove the plastic grill? if so how do I get the grill out
TIA

SPEEDO

the cowl grilles look like they "pop" off, might talk to a body man or a mechanic at a dealer to make sure. On the wiper pivot there is a ball and this retainer snaps over it and the wiper linkage slips over the retainer... make sense, I am sure it will once you see it, I had to replace one in my truck and it wasnt hard. try part number 28851-V0100(retainer) they dont show it for the newer trucks, it might save you some time and agravation

aaronford

The linkages on older sentras were one time use only. It was okay cause the linkage cost 8 bucks at the dealer. On my hardbody, the cowl grilles are released by pushing in the pin in the center of the clip and then removing clip. Not sure if yours are the same. Good Luck

__________________
Aaron Ford
95 2WD Nissan PU E
2002 Oldsmobile Intrigue GX
"The hard part about playing chicken is knowing when to flinch" Scott Glenn in The Hunt for Red October

xx_blkbird

Thanx for the assist guys. Much appreciated.I'll let you know how it goes