Keyless Entry

ac-pyro · Nov 27th, 2004, 12:10 AM

I need some help! I have a '96 Pathfinder and I just bought a replacement keyless Entry Key fob. I lost my copy of the programing instructions. Could someone help me! Yes I am a

ac-pyro · Nov 27th, 2004, 12:41 AM

I found the programing prodcedures

ID CODE ENTRY PRODCEDURE

Step 1) Sit in drivers seat, close all doors.

Step 2) Insert key into and remove it from ignition key cylinder more than six times within 10 seconds.
(Hazard warning lamps will then flash twice).

NOTE:
Withdraw key completely from ignition key cylinder each time.
If procedure is performed too fast, system will not enter registration mode.

Step 3) Insert key into ignition key cylinder and turn to ACC position.

Step 4) Push any button on remote controller once. (Hazard warning lamps will then flash twice).
At this time, the oldest ID code is erased and the new ID code is entered.

gass1998 · Dec 12th, 2004, 08:33 AM

Quote:

Originally Posted by ac-pyro

I found the programing prodcedures

ID CODE ENTRY PRODCEDURE

Step 1) Sit in drivers seat, close all doors.

Step 2) Insert key into and remove it from ignition key cylinder more than six times within 10 seconds.
(Hazard warning lamps will then flash twice).

NOTE:
Withdraw key completely from ignition key cylinder each time.
If procedure is performed too fast, system will not enter registration mode.

Step 3) Insert key into ignition key cylinder and turn to ACC position.

Step 4) Push any button on remote controller once. (Hazard warning lamps will then flash twice).
At this time, the oldest ID code is erased and the new ID code is entered.

do u know if this procedure works on a 2000 Nissan Frontier?

Blank · Dec 12th, 2004, 10:52 AM

it should, but you then have to manually unlock the drivers side door to end the sequence..