|
you need to remove the grille, its kinda tricky because of the plastic clips at the top, I think theres 4-5, you need to turn them about a 1/4 turn and pop out the connector, becareful not to break the plastic looking screw that you turn, (I dont remember if the turn lights are connect to the grille) if they are obviously remove those, then the on the bottom of the grille there are slots that the grille fits in, gently pull up. this gives you access to the 4 screws on the ring around the light, remove those and pull the light out and disconnect the wire connector under the boot. IMO I would replace both lights at the same time, I used Sylvania Performance series which are nice and bright.
__________________
Dave
96 4WD XE Reg. Cab ka24e
Calmini 3" SL, Steering, Lock-rite rear, LSD front
|
about seal beam
Linear Mode
