adjusting the throttle position switch

bkea · Mar 8th, 2006, 02:58 AM

I suspect I need to replace my throttle position switch which isn't too tough. However, I'm confused over how to adjust it. Can anyone give me some suggestions?

dvdswanson · Mar 8th, 2006, 10:47 AM

there are a couple of posts on the forum about this, try doing a search. I believe Spat was the one telling how.

bkea · Mar 8th, 2006, 12:25 PM

Well I guess I didn't realize I could search. So I did and finally found something posted by SPAT regarding the TPS. However, he still uses a term I don't understand. Unfortunately my mechancial skills are a lot better than my electrical.

Thanks for the enlightenment

dvdswanson · Mar 8th, 2006, 01:38 PM

what do you not understand and which post are you referring to?

bkea · Mar 13th, 2006, 05:26 PM

Sorry for the delay in responding. Been BZEE.

Spat says to "back probe the positive lead on the center wire" and its best to use a T-pin. What exactly is back probing and where can you get a T pin? Also, I thought the center wire was the ground, but that's going on bad memory.