bkea

We may recall I rebuilt and replaced the Z-24i engine my truck. I haven't been getting any gas to the TBI. I tested the wiring according to the FSM and everything seems be OK. Yesterday I pulled the fuel pump. Parts of it are pretty rusted. I removed the pump from the assembly and connected it to a battery charger set on low. I got no noise or pumping action. I assume this means the pump is bad. Everybody agree? I tried to disassemble it further to check the pump, but can't get into it other than pulling off the bottom plastic part that has the filter. There appears to be gummy rusty crud in a small inlet.

What is the best solution? I've heard the dealer now only carries the whole assembly, not just the pump. I imagine it is over $300. I've seen replacement aftermarket pumps available for around $180-220, but question whether they are an exact fit. Any advice is appreciated.

got mud?

i have the same motor in my 88 and just recently bought a fuel pump for it threw napa and they are a exact fit as for the rest of your unit clean it up with some fuel and injecter claener spray hope this helps
if your fuel gauge and every thing still works if not i would look into finding a intire unit

bkea

The fuel gauge worked fine. What was the cost of the pump?

got mud?

close to 200.00