nebrs13

im up to this

Motor Tranny harness and 3 puck and upgraded manifold w/ t25 1399+shipping 1599
ECU 160
MAF 55
Harness 280
20$ for SAAB Sidemount
20$ T3
285 eibach springs
gonna try a pre 90's 5.0 mustang fuelpump cuz its the same as a walboro

Left to buy
O2
Different MAF
5spd speed sensor
5spd Driveshaft and
5spd crossmember

Auto-manual on 89 hatch

 

HybridAndy

Just ordered a complete front cut from a 180sx (blacktop) today so I'm going to get started. Hopefully everything I need is included. I was going to go with just a motorset for less money but this is my first Nissan so I'm willing to spend a little money to get everything complete so I don't have to hunt for parts (at this point, I wouldn't even know what parts I needed to hunt for). Now I gotta go shopping for everything else and tighten up my budget.

ryan7o7

When only swaping the engine and not upgrading the rest of the car, how much would an average cost be for a front wheel drive sr20 swap under the hood of a GA16??

__________________
***GO LOOK AT MY BEAST*** Injen cold air intake, Dropzone lowering springs, OBX cat-back exhaust, OBX hi-flow cat, OBX headers, B&M short shifter, blue streetglow/interior neons, (2)12"RFPunch subs,(6)RF punch speakers, JBL600.1 amp, halo projector hdlights

Nismo1997

Search its been covered in the sr20de section

HybridAndy

I'd say he has since this is a few month old thread.

I haven't visited it but check under your chassis section for a swap forum (this specific forum is for S13 / 240SX rwd cars).

__________________
HybridAndy - 240sx/SR20 owner

'90 240SX hatchback - 180sx front clip on it's way, project car
'98 Civic EX - CTR headlight and grill, Kosei K1's, daily driver