installing clutch from clutchmaster on a 91 240sx

nIsMo_PoWeR · Jun 29th, 2006, 01:03 PM

how do i take off the top tranny bolt on my car and please tell me what i need to take off inorder to get that bolt off...do i need to take off all the wiring harness on the tranny too...would i need to resurface my flywheel or not...i got all the bolts that hold the tranny to the engine except the two top bolts...is there a way so i dont have to take everything off or do i have to take it all off???thanks

**rogoman** · Jun 30th, 2006, 12:56 PM

The top bellhousing bolts are a real bear to remove/install. You need to get the right size socket with a universal on it, then a long extension bar.

If the flywheel surface as surface cracks and/or is uneven, it should be resurfaced.

The wiring harness doesn't have to be removed, just unplug all the sensors.

zellx2004 · Jun 30th, 2006, 01:24 PM

I did this, if you're not afraid to move your engine a little. When I disconnected the tranny mount. I pulled down a little further, to get a sharper angle on the engine and trans. Be careful, with that. I did it slowly to the angle I needed. Then I put a long extension on a ratchet and got it out rather easily.

nIsMo_PoWeR · Jun 30th, 2006, 10:13 PM

Quote:

Originally Posted by zellx2004

I did this, if you're not afraid to move your engine a little. When I disconnected the tranny mount. I pulled down a little further, to get a sharper angle on the engine and trans. Be careful, with that. I did it slowly to the angle I needed. Then I put a long extension on a ratchet and got it out rather easily.

did u take the bolt off from under the car???