RotorSpec

I just put an AEM short ram intake on my car 3 weeks ago. My check engine light just came on today. Has anyone who has put an intake on your car encounterd the same problem? I think that it has something to do with the MAF sensor.

__________________
RotorSpec

cortrim1

I would check all the connections on the maf and the aem intake. The maf on this car is very sensitive I have heard that a short ram intake will some times cause a check engine light. As long as the car does not go into limp mode you should be ok.

__________________
:thumbup:
02 spec (173.1whp,178.9lbft)retired
94 se-r (342whp, 289lbft @15psi)
92 se-r (sr20ve with N1 cams DD)
www.cardomain.com/id/cortrim1

tekmode

Did you unhook the MAF when you installed it?

__________________
2006 Superblack Altima SE-R
HPautoworks

cortrim1

that will do it every time if the battery is connected

__________________
:thumbup:
02 spec (173.1whp,178.9lbft)retired
94 se-r (342whp, 289lbft @15psi)
92 se-r (sr20ve with N1 cams DD)
www.cardomain.com/id/cortrim1

RotorSpec

Why did it take so long to turn on? It has been like three weeks. I did unplug the sensor while the battery was hooked up.

By the way, does anyone know where I can buy the AEM extension so I can turn my short ram into a cold air intake? I think that all I need is that inlet tube.

__________________
RotorSpec

cortrim1

you can get it from any aem dealer, but you will have better luck getting it directly from aem. As for your check engine light I would go to autozone and get the code reset. Make sure to find out the code number. there is a list of the codes on www.b15sentra.net that will tell you what the code means.

__________________
:thumbup:
02 spec (173.1whp,178.9lbft)retired
94 se-r (342whp, 289lbft @15psi)
92 se-r (sr20ve with N1 cams DD)
www.cardomain.com/id/cortrim1