how do you remove sentra starter

I am pretty sure my starter (93 sentra) is going out.
Just cliked when I turned key.
After spending about an hour just finding the darn thing, I commenced to taking it off. Tried to remove for about 3 hours.
did manage to get one bolt off, working underneath, never could see or put my hand on the other bolt.
Just out of curiosity, I turned key, and the starter turned, although without a lot of vigor.
Put the mess back together, but I know starter is going out.
My question ? Do you have to remove all this stuff (intake manifold?) up top, to get to starter underneath? whats the easiest way, of should I just bite the bullet and take it to a mechanic.
PS - I have replace many starters and I have never seen one that is this difficult. someone please help!


thanks in advance!
jpritch2

[Nostrodomas]

There are two bolts holding it on. One on the right side, and one on the left. They are located close to the block.
If you still cant find them, I suggest you buying a hanyes manual. You can get them at any local auto parts store.

I was able to remove the bolt closest to the rear of the car.
I have both the haynes manual and the chilton. They both simply say "remove starter". Yeah right.
I am thinking of removing the passenger side tire (and perhaps wheel). Hopefully I will then be able to see the front side bolt and use a very long extension to remove.
Has anyone out there ever replace a starter on the XE? It is below the intake manifold , right in the center of the motor, facing out (to the drivers side)
Should I just remove all of the intake stuff above? and then work from above?
Help!!!
jpritch2

[Nostrodomas]

Try bolth of your ideas. You are bound to see it sooner or later.