Post your 1/4 mile times, dyno charts HERE.

BIGBULS · Jun 24th, 2003, 12:21 PM

Since the Nissan vs All area was closed down, and there was a topic like this, why don't we reopen it in the correct forum..........here!

If you've run you car at the strip, or have a dyno chart to show off (no matter how high or low it may be), post the numbers or a link here.

Also..........give us as full and total information as you can. Show your 60ft times, 1/8, 1/4, traps AND times...etc.

Finally.......can we make this a sticky?

BIGBULS · Jun 24th, 2003, 12:27 PM

My car (a 93 B13 SE-R) goes as follows:

Tristate Raceway, Earlville Iowa........last fall.

Mods: HS gen 5 header, timing advance (16.5 deg.), JWT clutch, ES motor mounts.

60' 2.322 (minor wheelhop)
330' 6.391
1/8 9.795
MPH 72.35
1000 12.728
1/4 15.214
MPH 90.06 (on the rev limiter in 3rd)

I have since added a HS CAI, but while my trap speed jumped to 90.84mph, I only managed a 15.393 this spring due to wheelhop out of the hole (Yoko AVS's with STIFF sidewalls do not spin smoothly).

Adam · Jun 24th, 2003, 01:48 PM

Ah yes, I forgot my old thread was gone. Here's mine:

Greddy SP cat back, UDP, WAI, Timing @ 18*, ACT clutch

atomicbomberman · Jun 26th, 2003, 06:38 PM

My car is a 1991 SE-R, 85k on stock Motor, stock clutch.
Mods are HS CAI, Gen3 headers, Stromung Mid-Pipe, Stillen Muffler, and JWT S3 cams, timing is 15.

My best time so far is 14.92@ 92.2mph, 2.27 60' time.

This was done at Sacarmento Raceway. Is the time right? I was actually expecting 14.7 with these mods... with a trap at 95 or so...

Well.. later that night I found that I have a REALLY bad exhaust leak,that could be part of the reason why I'm kinda slow.

GSRswapandslow · Jul 30th, 2003, 04:19 PM

10.96 @ 131
tuned with Wideband on the street

GSRswapandslow · Jul 30th, 2003, 04:23 PM

b18c1
83mm Darton(3rd gen) sleeves
RLZ Custom pistons
Pauter Rods
FACTORY bearings
Precision Turbo SC61
Todd made turbo manifold, very similar to fullrace
3" SS dp
tuned factory ECU with 2 step (7500), data logging, and full throttle shift
CM 5 clutch
DSS stage 4's
Quaifee LSD
Y80 tranny with 4.40 FD
hurst short shifter
M&H slick
Bogart Drag oN wheels
BIG ass intercooler

2.5" I/C piping
Greddy Type R BOV
Tial 48mm w/g
and blah, blah, blah All on 24psi

himilefrontier · Aug 1st, 2003, 10:03 AM

My stock 98 Frontier King Cab(KA24DE/5spd) ran a 11.2@61mph in the 1/8th at Sunshine Speedway when it had only 155k miles on it.That was with a slipping clutch too.

SentraE · Aug 13th, 2003, 12:22 AM

i have only ran my car twice since i got it and it was only at the 1/8 mile track. these runs are with only a intake (not CAI), timing advanced 15 deg., 2 1/4 in. exhaust and an accel super coil. i also had full interior and an audio system with one 12 in a heavy ass box. since then i have removed th stereo system some interior stuff including the entire heating system (including all the not so heavy air ducts under the dash) and i installed a cold air intake and eliminated the cat. when i get a lil more work done ill post more time

here are my times........
first run second run
r/t--------1.099--------------.840
60--------2.551--------------2.447
et--------10.942-------------10.954
mph------63.69--------------63.26

i think i could have done better with diff tires because i was on the stock 13in steelies with some mixed matched tires that had no grip whatso ever.

SR20 Who Knew? · Aug 25th, 2003, 05:41 PM

Well in San Diego there is no 1/4 track [that I know of...]
But theres a 1/8 track and my best was 11.258 @ 63.92 mph with my bone stock 98 SE-R...

REDLINEse-r · Aug 29th, 2003, 05:39 PM

well, wince we're posint 1/8th mile times mine are as followes:

my first time at the track and with dunlop sport a2's at 25 psi i ran a 9.56 at 74.xx mph. getting a 2.3 60ft. power mods:
warm air intake, act 6 puck clutch, nology wires, pacesetter header, and a flowmaster single chambered muffer.

second time at the track, the only difference was that i was running with slicks (20x14x6) at 9psi, first time too, getting a 1.98 60ft and ran a 9.20 at 74.xx mph.

oh i have a 92 se-r, and its forsale.

Katana200sx · Sep 1st, 2003, 07:45 PM

10.80 @ 64mph in the 1/8

mods are: wai, 2 1/4 crush bent exhaust, timing at 19 degrees, act clutch, full ES mounts. engine is a ga16de. i dont have a r/t or 60' bc they didnt give out timeslips that night. best 60' ever was a 2.4xx and best r/t was a .2xx(not like it matters).

niky · Sep 1st, 2003, 11:00 PM

1/4 mile? in my old GA16DE automatic? never tried it, but the closest i could figure... from a granny launch... 19's.

Katana200sx · Sep 2nd, 2003, 01:13 PM

doing the math...my 1/8 mile time comes out to be a low-mid 16...wooo im fast hahaha

7SPEED · Sep 6th, 2003, 01:51 AM

60' 2.33
330 6.34
1/8 9.71
mph 73.05
1000 12.65
1/4 15.15
mph 89.94

Thats 03 Spec V w/ pulley, cai, bal shaft removed

wheelzse-r · Sep 20th, 2003, 02:22 AM

At sturgis dragway 1/8th mile, elevation of 3200 ft., my 97 200sx se-r ran 9.046 at 77.75. The problem that i am having is my 60 ft. is only 2.09. i have been launching on a 75 shot of NX, with bfg drag radials and using it through the complete race. the car does have 137,000+ mls. on the orignal motor and clutch so i can only launch at about 3500 with out losing the clutch.