masham

I've been reading for a while and didn't find anything about porting an intake manifold for the Altima V6

Anyone have tried?

Tips?
good thing or bad thing or comments about that porting.

blitzboi

I'd suspect it's either because the stock intake manifold isn't a restrictive design to begin with, or because there are cheaper/better ways to make solid power gains (i.e. cold-air intake, cat-back exhaust, chipping, etc.), or both.

Anyone with more intimate knowledge of porting on an Altima please chime in....

__________________
Blitz - Nissan Enthusiast
Red 2005 Altima 3.5 SE 5MT (SOLD :( ) (cardomain site)
(Other Site) SHIFT_Next victim please

masham

I'll have every goodies to make it a bit faster. I have all the tools to ports the intake. I'll do it and post my feedback.

Thanks

AltibOi02

yes the stock intake manifold is restrictive. This is why some of people have wanted to swap it w/ 350Z intake manifolds. And this is where the Z gets its power gain vs. our VQ engine. It hasnt been said if it was done yet. But I dont think it will work....That is a plus to you that you have tools to port! Make sure you polish also after your done so you get a nice clean power gain....