Provided by Emax from a.net.
Tools: 1 hair drier
2 butter knives
1 sharp knive{swis army knife}
Silicone adhesive
First I started out by removing my headlight and bringing it into my room. Then I removed the HID ballast and all the bulbs{actually I left my HID in}. Next I grabbed my hair drier and began heating up the lower right corner of the headlight. Once the glue got good and hot I grabed my knive and started pushing through the outside of the headlight capsule while constantly heating up the area I was working on with my hair drier. I worked it through a litte bit at a time. Once I made about 7 inches of progress I put my butter knive into the center of the area I cut through, doing this allowed the glue to not come back in contact and re-harden. Then with my knife I started cutting through the other side{oppisite direction from where I started}, then after doing another 8 inches of cutting I shoved another butter knive into the parameter of the headlight. From there I just continued cutting and shortly after the headlight was comming apart, I now used my butter knives as wedges and slowly{gentley too} seperated the headlight. Once the headlight was completly opened I used another butter knive to pop out the little orange refector, it just popped right out. After that I looked everything over to make sure I did not leave any stains or fingerprints inside the headlight.
Now it was time to put the headlight back together. I just re-heated the glue a little bit at a time and pushed the headlight back together.
Warning: This procedure is very dangerous, you can very easaly screw up and crack your headlight housing. The key to doing this is taking your time and looking everything over twice before doing it. If you break your headlights, don't blame me.
Also, I examined the tail lights on your altima's and just like our headlights your orange tail light reflector will pop right out.
OR
Click here and follow the instructions.
o one other thing yall can check out my webpage if u want the website is 
Linear Mode
