Havack

Does anyone have better wiring diagrams for a 92 or a 94 pickup than what Alldata has? Specifically I need clearer pictures of Joint connector A. I am a little lost to what is beeing joined at this union. I see power and ground going to it.

My project is the rare swap of replacing the I4 with a V6. I am about to start splicing wires but I want to clear up a few final pieces to make surewhat need to be changed on the harness.

Ben

88pathoffroad

Check phatG20.net for a factory service manual.

__________________
Admin of NPORA, mod for Nissan-Infiniti Forums, NissanForums.com, NissanHelp.com, AllNissans.com and VGPowered Forums
'88 Pathfinder: 6" of lift, 33x13.50 Swamper LTB's, Rancho 9000's, L&P Stage 3 steering system, K&N, Pacesetter headers and 2.5" exhaust, Lock-Right locker, 110A alty and electric fan swap, dual batteries, 700W+ worth of PIAAs, etc.

Rogue_Wulff

phatG20.net only goes back as far as 96 (for the hardbody), and the wiring diagrams are not all accurate for earlier models. Basic wiring may be similar, but the entire engine harness will likely be much different, due to the OBD2.....

__________________
1990 King Cab 2WD 223K and counting, KA24E 5 spd
1983 Mazda RX7 for fun

Havack

I was hopingthat someone else might have the FSM and could explain the joint connector to me as the $3000 a year Alldata pics are just not that clear and I don't want to buy a FSM for both vehicles.

Does anyone understand joint connectors or have a 92 or 94 FSM and could send me a copy of a page or two?