Help! I relocated my batt to the trunk and now my car won't start!
OK I put my battery in my truck (making space for my IC piping)
and now my car won't start. I used 1/0 gauge wire for + & ground.
I have a stinger batt. which is suppose to be as good as an optima
yellow top. The ground is running to my seatbelt bracket in the
rear of the car. I did not redo the ground wire in the front that is
attached to the thermostat and body of the car yet. The
connections on the batt are tight. It was difficult to start from the
beginning but would crank (last Sat.). I just had to step on the gas
to get her going. Now it won't even crank over. To get home from work
I had to be pushed down a hill and dump the clutch (twice) before
it would start :-( I got home after driving 15 miles tried it again,
nothin but a tick tick and then silence. All of the electrical work fine.
Any thing jump out at you? I need some help fast. Thanks peeps.
GTIRoids
I have the accessory wire hooked up I thought. What I did was cut the normal terminal (positive) that hooks to the battery and attached it to the 1/0 that I have running through the car to the circuit braker to the positive on the batt in the trunk. I have it hooked to the 2 wires that where originally hooked to the the batt. Is this correct or am I missing something? GTIRoids
I think I'm goint to buy one of those audio connectors that fit on top of the battery and connects all of the wires and use it to connect the wires in the front. I think that's where my problem is. Thanks for your help buddy GTIRoids
No offense, but could you please stop saying GTIRoids after each post. And I hope the situation works out for you.
__________________
Sun Burst 04 Spec-V: Gen II Nismo CAI - Megan Racing header - IM Pulley - JWT Cams - Motor Mount Inserts - HPA Downpipe - Apex'i WS2 - Faktion Gen2 Short Shifter - Custom Lip - Tinted Windows
Its just annoying when you read a post and you read the same thing over and over again.
__________________
Sun Burst 04 Spec-V: Gen II Nismo CAI - Megan Racing header - IM Pulley - JWT Cams - Motor Mount Inserts - HPA Downpipe - Apex'i WS2 - Faktion Gen2 Short Shifter - Custom Lip - Tinted Windows