Timing help

BeEleven · Jun 29th, 2003, 05:43 PM

I'm finishing up my motor and I was working on the timing stuff...I got the cam and sprocket installed right, I got the timing plate on, the jackshaft and crankshaft seals and crank bearing, but now something isnt right. There are 3 little round plates that go on the end of the crankshaft with the sprocket for controlling the timing belt i guess and they dont all fit...it seems to work okay with one of them....i dunno...does someone know what all is supposed to go on the crank and in what order (everything from the block to the timing cover) thanks....my manual sucks.

BeEleven · Jun 30th, 2003, 11:54 PM

I figured it out....in case anyone had the same question (ya right)...the order of parts fromt he crank out is as follows....
1 front main cap
2 spacer with cupped side facing gears
3 timing plate with seal
4 bearing inside seal on crank
5 inner belt allignment plate (cupped to fit gear)
6 crank sprocket
7 timing belt
8 outter belt alignment plate (flat)
9 timing cover gasket
10 timing cover
11 aluminum ring
12 2 cover screws
13 pulley
14 crank bolt and washer (19mm)

maybe one day this will help someone