kellen_wynn

Does anyone know how to fix or replace the screws to adjust the light projection on the Halo headlights. The one I got is pushed foward and the screw to adjust it isn't set right. If anyone has a passanger side Halo lamp for sell I'll buy it.

sethwas

How do you mean pushed forward?
You can always cook the unit in the oven at 150 for 10 minutes, separate the clear plastic lens, and then just push the screw back by hand.

Seth

__________________
my signature is at the bottom of this thread. its because its too long. Lots of important links there.
http://www.nissanforums.com/showthread.php?t=46259

kellen_wynn

If I did that would it seal back, watertight, like it was before or will I need to buy some glue for it?

johnsonsRIDE

some silicon will work if i am correct

__________________
http://www.cardomain.com/ride/322684

sethwas

It would seal back, and they aren't water tight in the first place, that's what the vent is for.
But splashes and dunking it will not penetrate. However you have to cook it again to put the lens back on.

Seth

__________________
my signature is at the bottom of this thread. its because its too long. Lots of important links there.
http://www.nissanforums.com/showthread.php?t=46259

B14_Stealth

my halos leaked eversince i got them