|
1. remove all bulbs
2. cover any metalic parts
3. pre-heat oven to 200
4. place on aluminum foil, and then into the oven for 10 minutes
5. RIght after step 4, turn your vent on.. just incase
6. remove projectors, use a flat head screwdriver/knife to see if the silicone is loose enough to remove the plastic lense (if not loose enough more oven time is needed)
7. the projector "chrome" part that has the 2 holes in it, also comes out, and that will be what you are working with..
8. sand/mineral spirt the hell out of htat thing, until it is black.. becuase its plastic
9. primer/prep/paint/clear coat
10. re-install plastic cover, after letting it dry/cure
11. re-install plastic lense, put in oven for about 5 minutes to heat up silicone, push very tightly together, then if you want to be safe, use some acrylic silicone sealant.
12. install bulbs
13. install rubber bulb protectors
14. install on car
15. aim
16. enjoy
|
Linear Mode
