anyone looking to change there 91-94 gauges with no tach?well heres the solution go on e-bay and bid on a set of reverse indiglo gauges for the 95-99 sentra no tach.or if not go to www.procarparts.com and purchase them there .they made a mistake and made the wrong gauges.there really for a 91-94.pics of my car are in www.printroom.com under user put chuckone and there you will see them on and off.good luck
He said tachLESS. All SE-R's came with tach's. As for some of the 1.6's, we did not. Which sucks. I'm just going to get an aftermarket 2 1/2 to 3" tach and chill if just left of my steering column hump.
yo chuck i cant find um on procarparts. and were did u get the carbon fiber pieces on the dash and were the gauges hard to put in.thnx in advance bro.latez
chuckone - I was wondering if you could help me out on the wiring part of the reverse indiglo gauges for me?... I recieved my gauges yesterday and I'm planning on installing them today... I took a look at the instructions; getting to the stock gauges and removing all the screws I understand all but the wiring part seems to be a little confusing... the instructions that were provided from Procarparts aren't great... so I was wondering if you could help me with the wriring issue? Thanks.
i wired mines to the dimmer switch.just get a light tester and put in in the back of the dimmer plug .find the wire that has power when the lights are on and ground .you should ba alset with that.good luck
chuckone - Thanks for the reply... I've got another question; and yet another problem . The reverse speedo gauge... well... doesn't seem to fit over the speedo needle on the stock gauge... the black covering over the speedo pointer is too large for the reverse gauge to slip over... I was wondering how you took care of that problem? Did you remove the black covering off the speedo pointer? If so, how?
I have the same question, how the hell do you take off the original black face plates? Do I have to take off the needle or what? I tried putting in a new bulb last week and i was confused as hell.
with the new gauges all you have to do is take out the small screws that hold the gauges in .slip the new ones over the needles and put the small scres back on ,all done
on the site www.procarparts.com i was looking for the 1991 face plates when i noticed the 95-99 face plates which looked awsome cause the were lit in the middle at well as the needle (it appears) http://www.procarparts.com/store/dis...=NIS-95SER-REV and is it possible to fit a 95-99 faceplate ona 91?
Or is there another company that sells something similar? Because I am really liking the 95-99 gauges...
if yours doesnt have a tach .go to procarparts and under 95-99 sentra/200sx check out page two and the last gauges on that page are made for the 91-94.they made a mistake.i bought these for my 94 le and there direct fit .check out pics of my car at www.printroom.com under user id put chuckone and ther you should see the gauges on my car .good luck.
reverse indiglo for 91-94 sentra no/tach
cant find um
kool
. The reverse speedo gauge... well... doesn't seem to fit over the speedo needle on the stock gauge... the black covering over the speedo pointer is too large for the reverse gauge to slip over... I was wondering how you took care of that problem? Did you remove the black covering off the speedo pointer? If so, how?
Linear Mode
