I just completed restoration of the trunk area in my B210. The hardboard rear partition that separates the luggage area from the fuel tank [that is on the other side of it] had been water damaged, so I found an almost perfect match in the material for it at the Home Depot. It's called 1/8" X2" X4" HDBD. It's basically that brown pegboard material, but without the holes. I traced the original one and carefully cut the new one out of the hardboard with excellent results. I wire wheeled and clearcoated the jack, handle, and hold down as well. The original bias ply Toyo white stripe tire was cleaned and detailed with a tire dressing. Lastly I respatter painted the floor in the original grey. I replaced the torn trunk seal with a good used one from a B12 sentra parts car. It is trimmed to fit.
...no more nasty looking trunk here.
Linear Mode
