Ruben

Just had my Nismo Front Sway bar installed to finish off my suspension and I'm very happy with the results. It pushes a bit under throttle in slow turns, but on fast sweepers, it holds like glue.

My set-up now is:
OEM Strut tower bar
Nismo FSB
Nismo LTB
Nismo Springs/Strut combo
Stillen RSB (set on stiff)

Its a little twitchy with almost all the body roll gone, but I'm almost used to it. It really inspires confidence...

__________________
Ruben - O.G. Club Mofo Mobster
2003 Chevrolet Corvette Z06
The Z06 / Z06 Replaced 350z / 350z Replaced Spec V / Spec V Replaced 3.5 AltimaSE

chimmike

take the front sway bar out and eliminate the push

__________________
My Website, check it out!
2003 Redline 350z Enthusiast 6MT Turbonetics Powered

Ruben

I just have to modulate the throttle a bit, to get the rear to catch up... just taking a little getting used to.

__________________
Ruben - O.G. Club Mofo Mobster
2003 Chevrolet Corvette Z06
The Z06 / Z06 Replaced 350z / 350z Replaced Spec V / Spec V Replaced 3.5 AltimaSE

tekmode

adjust the rear sway to full stiff

-nm you have stillen, not nismo

__________________
2006 Superblack Altima SE-R
HPautoworks

chimmike

stillen is adjustable, iirc.

__________________
My Website, check it out!
2003 Redline 350z Enthusiast 6MT Turbonetics Powered

Ruben

I have it on stiff, but I need to play with the position of the bar. The further forward you move it, the stiffer it is.

__________________
Ruben - O.G. Club Mofo Mobster
2003 Chevrolet Corvette Z06
The Z06 / Z06 Replaced 350z / 350z Replaced Spec V / Spec V Replaced 3.5 AltimaSE