joeyxryan

In my haynes it says that i have to disassemble the whole axle just to replace the outer boot. I was wondering if there is another alternative? please help like quick.

__________________
HS CAI, advanced timing, Fidanza Lightweight Flywheel, UR Underdrive Pulley, B&M Short Throw Shifter, Tein S-Techs, SE-R wheels, SE-R sideskirts, John Deere Blitz Black!

I'm tired of my usernamee

its very right. The outer cv boots are a pain to replace. you have to take out the whole axle to get at them easier and they are quite difficult to remove if you have never done it before. It took me quite a while to do it. I could say that cost wise it would be easier to replace the axles if you can get a good price. I got mine for 66 dollars each after core rebate.

__________________
www.nissanpacific.com

joeyxryan

yea i have the axles out b/c i recently replaced the motor and clutch but now i have the task of disassembling them bitches

__________________
HS CAI, advanced timing, Fidanza Lightweight Flywheel, UR Underdrive Pulley, B&M Short Throw Shifter, Tein S-Techs, SE-R wheels, SE-R sideskirts, John Deere Blitz Black!

I'm tired of my usernamee

well good luck with that, should take a long time if ya end up doing it youself

__________________
www.nissanpacific.com

joeyxryan

well i gave up and went and bought some split cv boots so no worries now

__________________
HS CAI, advanced timing, Fidanza Lightweight Flywheel, UR Underdrive Pulley, B&M Short Throw Shifter, Tein S-Techs, SE-R wheels, SE-R sideskirts, John Deere Blitz Black!

IanH

Just for your info :---
There is a cone type stretcher that was used by a shop that will stretch it over the CV joint but the boot was a silicone one sold for this purpose.

__________________
1997 Sentra GXE .... SOLD
1997 S-ER 5 sp yea !!!
2003 Pathfinder SE 4WD
Ex- 2001 Sunny N16 RHD (N16 Nissan Bluebird Sylphy)