Neva2wicked

Does anyone know how difficult it is to replace the headlight harness (from the connector back?) I was adjusting my Halos last night and I noticed that some areas are exposed.

To clarify- I didn't use the harness that came with the Halos (used Seth's setup) but the stock harness.

Thanks

__________________
Da Black CHIC

xbrandonx

is there enough wire to left to let you cut it off strip it and put some new wire in? It may be hard to get some of the places but just get just get some connectors and hook them up. When I put my wires in I wrapped them compltly in electrical tape to shield them from everything else, and to make installation a bit neater.

__________________
SE-R SpecV
Those who would give up Essential Liberty to purchase a little Temporary Safety, deserve neither Liberty nor Safety. - Ben Franklin

Neva2wicked

I got one of the areas for my driver-side corner light but every now and then, depending on how I stop, I get the 'fast blinkers'

I can squeeze my hand in there for one of the spots but wrapping it would be a PITA. TBH I was just hoping to replace the entire thing on both sides cause I am concerned about an unexpected electrical fire. That's the last thing I need.

__________________
Da Black CHIC