Neva2wicked

One of the bulbs on my car blew and I can't get the assembly out so I can replace it. Can anyone point me in the right direction? Kinda sucks considering its easy to take off the rear lights, yet am completely unable to get off the front ones.

Thanks a bunch

P.S. Yes I've searched using "b14 headlight removal", "bulb replacement", "light assembly removal", "bulb installation", and a dozen other names.

 

Wufaded

so you just wanna swap out the bulbs from your headlights, right??

__________________
Club MoFo Votary - My 200SX

zeno

huh? Are you asking about the front or rear lights? To get the headlights out, pop the hood and look for a little wire latch behind the headlamp assembly. Undo that and that's it.

__________________
Garage Sale - buy my junk!!

My Car!
Dreaming of turbo..... :fluffy:

NotAnotherHonda

yea...the ones in the front are simply held on with a snap kinda thing

__________________
95 200sx se. sr20de, gt28r, bb manifold, forge fmic, greddy bov and bc, tial 38mm, walbro 255, apexi tt, 3" exhaust with magnaflow, 3" downpipe, jgy clutch flywheel and fuel rail, msd 50#'s, cobra maf, jwt ecu and s4's, nismo fpr, autometer, nissport adaptors, fal pushers, ur pulley, m/t 22x8x15 et drags.

Captain Obvious

and the rear is a twisty thing they might be a little stuck but just jwist them and theyll come out the front ones looks lika a metal hanger of sorts just pull hard but dont get your fingers snaped like I did it hurts like a biatch

 

clsindustries

As straightforward as the job SEEMS like it should be. There's an inordinant amount of crap around the headlight that you'll have to work around. I can only imagine that if you have thick fingers this job is gonna be a major PITA.

Just look on the back side of the headlight assembly. There'll be a plug that you'll need to pull and I believe there's a wire type clamp you'll need to pull off BEFORE you yank the plug out of the headlight.

Patience and a good well placed yank should do the trick.

__________________
Carlos
99 Platinum Gold Sentra SE-L
'Breathin' easy in and out! Thank you Magnaflow!'

Exalta

If you still have the manual, there are detailed instructions regarding the aforementioned topic there.

If not: Just follow what they said.

-Pull off the bulb plug by pressing on its side and pull
-twist the plastic cap counterclockwise to remove it
-pull off the rubber seal using its tab
-take off the retaining clip

Be sure to put those back properly as to avoid dirt/soot from getting inside your headlights.

__________________
2000 Nissan Exalta Sentra STA (B14) /2003 Nissan X-Trail /
NissanBayan PI
(Click on the links above)