i read a few days ago in these boards that all you have to do is heat the outside edge of the lens with a blow dryer or heat gun, where the seal is, and pull it off. the amber bulb cover should pop off with little force. then all you have to do is super glue the lens back on.
Let me know how it turns out....I am in the process of doing the hair dryer /crazy glue thing to get that bullsh-t amber plastic out of the headlight....
I don't know why they put that in there and made it so non-accessible to begin with!!!!
Let me know how it goes
__________________
More mods in progress...currently got Hotshot CAI, 96' G20 ECU, Stillen 4-1 headers,custom 2.25 piping w/ Skunk2 welded exhaust, front strut bar, X-drilled/slotted fr. rotors , and Damani 5 Hyperblack 17's
And a bunch of interior mods...
They do it because in some states you need a reflector so other cars can see you. The reason why its so hard to take out is because they figure most people wont take them out and also so they wont fall out.
I am not knocking the law in various states...trust me if you take that amber plastic cylinder out of the light and replace the bulb with an amber or super white people should be able to see you just fine.
All I'm sayin' is they could have had the screw accessible from the outside (rear housing of the light) instead of the inside!!!!
Overall, the design of the light is bad...but looks good especially with projectors or crystal clear headlights..
Take it light...
AB
__________________
More mods in progress...currently got Hotshot CAI, 96' G20 ECU, Stillen 4-1 headers,custom 2.25 piping w/ Skunk2 welded exhaust, front strut bar, X-drilled/slotted fr. rotors , and Damani 5 Hyperblack 17's
And a bunch of interior mods...
200 Deg for 10-15 min. Then pull apart with a screwdriver and razor blade. (razor blade is to cut the glue as you seperate it. Go slowly. When you put it back together a little silicone in the troph and put it back together and back again at the same temp and time. Push it back together. I did it with my crystal clears when I installed C/F in them and the corners....
Originally posted by nismo200sxy jus buy the clear corners they are like 25 bucks on ebay
The corners they are refering to are not the same as the ebay $20 ones.... These are the Lucino/Asian market crystal clear corners... They are much nicer and better quality..
Where can i get these asian market crystal clear corners. Are their any other corners besides clear corners for the 95-99 sentras?? What about euro clear?
Syndicate is right!!! Do not use super glue, Whenever you are dealing with lights use silicone glue to seal it back up, that is the best, and you can buy it at like lowes or Home Depot. You can also use it to make clear tailights If you know how to do that. I also recomend letting the crystal corner sit out for bout half an hour after you reseal it with the silicone glue!!
what about the clear corners from APC? are they any good? they looked better than the ones on e-bay? for $25 more, i would probably get them, if they are any good.
Stanzaboi - I got the same problem...
they are temp out of stock. don't know for how long or if they could still order them. sorry.
Linear Mode
