The1.6

What all do i need to make a safe turbo kit assuming i already have the piping and a welder?

__________________
Lehoozeher :loser:

chimmike

a lot more than piping and a welder.

you need some sort of fuel management.

read the turbo forum, check out the FAQ sticky in the GA16 section as well.

__________________
My Website, check it out!
2003 Redline 350z Enthusiast 6MT Turbonetics Powered

BikerFry

^^^Wow you really held back on that one! I think that was the nicest reply I've ever seen out of you! Not yelling search like I'm sure you wanted to really does seem to make this place a lot more welcoming.

He's right. You need to know a whole lot more, but you're in luck: There's a whole lot of knowledge on turbocharging your car on these forums! Start reading and good luck!

__________________
Is this forum still full of n00bs learning that you can't boost your daily driver on a part time retail income?

cool_rebel671

you're going to need an intercooler, ecu. you're really going to have to research this. there's a site that you might find interesting. maybe you can use it as i guide. idk. i know you don't have an se-r but i think it's worth a look.
http://www.nissanperformancemag.com/...projectser.php

BikerFry

Assuming he already has the piping and a welder, all he needs in addition is a safe turbo kit.

__________________
Is this forum still full of n00bs learning that you can't boost your daily driver on a part time retail income?