88 e16i

my passenger wheel wobbles when i go over large bumps...especially when im taking a turn. When the car is parked i can push on the top of the tire real hard ..and then pull back from the back side and the tire moves very slightly..is this a ball joint problem?? if so where can i buy a replacement for a good price?

__________________
88 Sentra 5spd (grocery getter)
600whp integra turbo 95% complete

FS: e16i head + block $50+ ship each

minute rice sentra

sounds like bearings are shot but if it's the ball joints, here's some info
http://www.nissanforums.com/showthre...ght=ball+joint
http://www.nissanforums.com/showthre...ght=ball+joint
hope that helps.

__________________
My sentra! My 200SX! My Brother's 300Z!

Webfoot

IDk, usually you can hear a bearing going out. Put on a jack and give it a spin. grinding is bad.
I was getting a wobble on the Suby but that was becaus the axle nuts were like almost a full turn loose. There are numerous components that can cause a wobble. With you youngins, a bent rim is likely. Could be alignment, a blown strut, warped rotor... These are old cars. IMO, the whole front end should be gone through and upgraded.
Can't wait for the next project.....

__________________
87 SE Sport Coup
81 Toyota Diesel Pickup Cough Cough
98 Durango SLT Plus 5.9L V8 Magnum